Posted by BERT on September 24, 2000 at 19:58:56:
In Reply to: Kalart RF Infinity Adjustment posted by jon wells on September 24, 2000 at 13:23:18:
Jon---Sounds like someone has tried to adjust
the RF before you got it!! Make this test--the
actuating arm should be vertical (inside the body)
when the RF shaft is rotated toward the back
as far as it will go!
The arm may have loosened--test 2--check the
override spring (at the end of the RF shaft)see
if it is being used--(if the arm is to far forward
the spring is engaged to relieve pressure on the
RF shaft)Busch may or may not have this spring
If the shaft is out of alignment--your in for some trial and error
time to get it right--Suggest
you do not change it>>unless you are sure that it
is out of position<< Bert