Posted by Les on August 29, 2000 at 11:13:04:
In Reply to: Bellows removal on 4X5 Pacemaker posted by Nik Nikiforou on August 29, 2000 at 07:35:16:
: I have two 4X5 Pacemaker Crown Graphics, one a parts
: camera with a very good bellows and another a working
: camera with a bad bellows. I would like to swap the
: good bellows from the parts camera to the working one.
: I know how to remove the bellows from the front
: standard, but can't figure out how to detach it from
: the back. Can anyone help me with some tips on
: detaching and reattaching the bellows at the rear?
Remove the 6 small black screws that hold the entire back on the
body. There are three at the bottom, two at the top and one where
the film holder goes in. Once the back is removed you will find
four metal tabs and two clips. Bend the tabs back and remvoe the
clips and the bellows will come out. The trick is not to break the
metal tabs. Good luck.
Les