Graflex.org Forum Index Graflex.org
Get help with your Graflex questions here
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

watson press 3x4

 
Post new topic   Reply to topic    Graflex.org Forum Index -> Speed Graphic Help
View previous topic :: View next topic  
Author Message
Kim



Joined: 10 May 2001
Posts: 44
Location: upstate NY

PostPosted: Fri Aug 03, 2001 8:34 pm    Post subject: Reply with quote

this would probably be more appropriate in the non-graflex forum but there is so little traffic there.

i have a beat up watson press camera, actually the worst part is the bellows, although it is set up for 3x4 the box is plenty big enough to use 4x5 if I can adapt the back

It is not at all obvious, however, how to remove the back. I suspect if I sand the finish off I will find some filled screw holes but thought I might pose the question here on the chance someone might have the answer.

BTW the interesting thing about this camera is that the front standard rises, shifts, and tilts in both directions and so it is actually closer to a field view camera than the standard graflex.

thanks

Kim
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    Graflex.org Forum Index -> Speed Graphic Help All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group