Graflex.org

[Kim]

this would probably be more appropriate in the non-graflex forum but there is so little traffic there.

i have a beat up watson press camera, actually the worst part is the bellows, although it is set up for 3x4 the box is plenty big enough to use 4x5 if I can adapt the back

It is not at all obvious, however, how to remove the back. I suspect if I sand the finish off I will find some filled screw holes but thought I might pose the question here on the chance someone might have the answer.

BTW the interesting thing about this camera is that the front standard rises, shifts, and tilts in both directions and so it is actually closer to a field view camera than the standard graflex.

thanks

Kim