Graflex.org Forum Index Graflex.org
Get help with your Graflex questions here
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

speed graphic

 
Post new topic   Reply to topic    Graflex.org Forum Index -> Speed Graphic Help
View previous topic :: View next topic  
Author Message
artblack



Joined: 29 Jun 2002
Posts: 1

PostPosted: Sat Jun 29, 2002 7:04 pm    Post subject: Reply with quote

If I pull lens board out on my speed graphic-
it has been getting stuck on the rails - just past the hinge area of the camera- which makes it impossible to focus- or return to closed position. I can't see any "stops".

Also, the lens board has tilted down- but don't know how I did it.

Haven't used the camera in several years.
Back to top
View user's profile Send private message
Les



Joined: 09 May 2001
Posts: 2682
Location: Detroit, MI

PostPosted: Sat Jun 29, 2002 7:07 pm    Post subject: Reply with quote

look at the chrome struts that hold the bed in the dropped position, if you push in on them they should allow the bed to come up to normal, this should allow the front standard to pass the hinges. If the lens is a typical 127 135mm the stops should be on the rails about 3 inches from the hinge.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Graflex.org Forum Index -> Speed Graphic Help All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group