View previous topic :: View next topic |
Author |
Message |
artblack
Joined: 29 Jun 2002 Posts: 1
|
Posted: Sat Jun 29, 2002 7:04 pm Post subject: |
|
|
If I pull lens board out on my speed graphic-
it has been getting stuck on the rails - just past the hinge area of the camera- which makes it impossible to focus- or return to closed position. I can't see any "stops".
Also, the lens board has tilted down- but don't know how I did it.
Haven't used the camera in several years. |
|
Back to top |
|
|
Les
Joined: 09 May 2001 Posts: 2682 Location: Detroit, MI
|
Posted: Sat Jun 29, 2002 7:07 pm Post subject: |
|
|
look at the chrome struts that hold the bed in the dropped position, if you push in on them they should allow the bed to come up to normal, this should allow the front standard to pass the hinges. If the lens is a typical 127 135mm the stops should be on the rails about 3 inches from the hinge. |
|
Back to top |
|
|
|