Graflex.org Forum Index Graflex.org
Get help with your Graflex questions here
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

grafmatic back

 
Post new topic   Reply to topic    Graflex.org Forum Index -> Film Help
View previous topic :: View next topic  
Author Message
robertbuc



Joined: 21 May 2002
Posts: 1
Location: new york

PostPosted: Wed May 22, 2002 3:32 am    Post subject: Reply with quote

does anyone know how to remove the small film counters (circular which leaves imprint on film) from grafmatic film back
Back to top
View user's profile Send private message
45PSS



Joined: 28 Sep 2001
Posts: 4081
Location: Mid Peninsula, Ca.

PostPosted: Wed May 22, 2002 8:06 am    Post subject: Reply with quote

To remove the index wheel proceed as follows: READ ALL STEPS FIRST!
1). Remove spectrums
2). Place dark slide handle facing you with dark slide up.
3). Locate and remove screws on the sides of the frame closest to you.
4). Slide inner housing from outer housing. NUT PLATES THAT SCREWS ATTACHED TO WILL COME OUT! Pay attention to their position for reinstallation.
5). Hold dark slide lock wheel and remove its screw. SPRING AND SMALL BALL ARE UNDERNEATH! Also there is a brass washer.
6). Carefully lift lock wheel off and remove ball and spring.
7). Remove screw from other end of the same plate.
. Remove dark slide end plate; lock lever and dark slide may have to be manipulated.
9). Position as in step 2 and pull dark slide out as far as it will go. Push in slightly and feel (find) catch lip on right far edge bottom of dark slide. A 5/16 square block on a spring engages the dark slide lip to prevent it from coming out.
10). Insert a .020 to .025 feeler gage (or something similar) between the dark slide and the spring loaded retainer block, and remove the dark slide.
11). Lift index wheel off its spindle.
12). Hold down dark slide retainer block and reinstall dark slide in its slots and push past retainer.
13). Continue to reassemble in reverse order. A small dab of Lubriplate or white lithium grease applied to the bottom of the dark slide lock wheel will aid in holding steel ball in place. Screw has a sholder that wheel must set on to function properly.




_________________
While a picture may be worth a thousand words, a quality photograph is worth a million.



[ This Message was edited by: 45PSS on 2002-05-22 01:20 ]
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    Graflex.org Forum Index -> Film Help All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group