View previous topic :: View next topic |
Author |
Message |
LelandRay
Joined: 24 May 2001 Posts: 115 Location: Mississippi
|
Posted: Sun Oct 07, 2001 1:13 pm Post subject: |
|
|
I have a Rodenstock 135 lens with a very recently CLA'd and repaired shutter, and I'd like to put it on my Speed. About the only thing that's stopped me is that the only cam I have handy is for a 132mm. So how far off is focusing going to be? I really didn't want to go to the trouble of setting my infinity stops if rangefinder focus is going to be iffy.
![](http://www.vangargoyle.com/priv2/lf093001-01.jpg) |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
Les
Joined: 09 May 2001 Posts: 2682 Location: Detroit, MI
|
Posted: Sun Oct 07, 2001 6:14 pm Post subject: |
|
|
I'd set it up and check.
With the camera on a tripod find a nice infinity target, something 1/2 mile away is nice.
Now with a loupe on the ground glass, nudge, cajole, teak the front standard to were the infinity target is sharp when the standard is locked down. Make a pencil mark on or put masking tape accross the rails to act as temporary infinity stops.
Now rack the standard out so you can put the cam in or do this ahead of time. Check to see if the ground glass and the rangefinder agree-with infinity -they should since the rangefinder point for infinity is always the same.
Then trapse around the yard targets at different distances and look at the and see where the GG and the rangefinder start to depart.
Also when they finally do start to diverge, stop down the lens a bit and see how much that helps. It might be possible that this cam might be soft at wide open when the subject is closer than 15ft but by f8 you could get sharp rangefinder photos down to 8ft. |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|