Graflex.org Forum Index Graflex.org
Get help with your Graflex questions here
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Removing hood on auto graflex

 
Post new topic   Reply to topic    Graflex.org Forum Index -> Reflex Help
View previous topic :: View next topic  
Author Message
mhcfires



Joined: 05 Mar 2009
Posts: 5
Location: El Cajon, CA

PostPosted: Sat Mar 14, 2009 11:06 pm    Post subject: Removing hood on auto graflex Reply with quote

I picked up a 3 1/4 x 4 1/4 auto graflex, managed to get the shutter unstuck and operational, the mirror unstuck and working, but need to replace the hood, which is being held together with gaffer's tape. It would als make it easier to clean the GG if the hood were removed. Bag-mag seems to be in ggod shape, I picked up a box of film from Freestyle, so I'm about ready to go.
_________________
The early bird may catch the worm, but the second mouse always gets the cheese!
Back to top
View user's profile Send private message
Billy Canuck



Joined: 04 Apr 2006
Posts: 165
Location: Calgary AB Canada

PostPosted: Sun Mar 15, 2009 5:30 pm    Post subject: Reply with quote

There are two metal strips on each side of the rear of the hood near the top. These are held to the door by two brackets. Each of the brackets is fastened to the door with two screws. If you remove one screw from each of the brackets, you can swing the brackets aside to release the hood. At the bottom front of the hood is a spring clip attached to the inside of the camera front. Just push this in and the hood will lift off.
Back to top
View user's profile Send private message Send e-mail
mhcfires



Joined: 05 Mar 2009
Posts: 5
Location: El Cajon, CA

PostPosted: Mon Mar 16, 2009 4:02 am    Post subject: Reply with quote

Billy Canuck wrote:
There are two metal strips on each side of the rear of the hood near the top. These are held to the door by two brackets. Each of the brackets is fastened to the door with two screws. If you remove one screw from each of the brackets, you can swing the brackets aside to release the hood. At the bottom front of the hood is a spring clip attached to the inside of the camera front. Just push this in and the hood will lift off.



Thank you so much, It worked.
_________________
The early bird may catch the worm, but the second mouse always gets the cheese!
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Graflex.org Forum Index -> Reflex Help All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group