View previous topic :: View next topic |
Author |
Message |
essessem
Joined: 19 Feb 2003 Posts: 48 Location: California
|
Posted: Thu Feb 26, 2009 9:34 pm Post subject: Hole diameter + cam for 135 WF Ektar ƒ6.3 |
|
|
I'm hoping to find a ready-drilled lens board (lots of them on evilBay right now), but will probably have to go to the machinist. Looks to be 43-44mm using the ruler. Lens is mounted in a Flash Supermatic (with ASA plug!). I don't suppose there is a chart somewhere on line?
Also, anyone know which rangefinder cam this uses? Looks like it could be #5, 6, 7, 31 or 32. _________________ Speak softly and carry a big camera. |
|
Back to top |
|
|
Les
Joined: 09 May 2001 Posts: 2682 Location: Detroit, MI
|
Posted: Fri Feb 27, 2009 4:01 am Post subject: |
|
|
If you have a flange (fat retaining ring with wood screw holes) then I'll bet 444-45mm hole would be fine.
A retaining ring needs to seat in the hole rather than the threads, so Kodak recommends 47mm
The cam will be tricky. Each lens is a bit off from it's stated focal length and Graflex insisted that you had to measure the lens's actual focal length to match it with a cam. _________________ "In order to invent, you need a good imagination and a lot of junk" Thomas Edison |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|