Graflex.org Forum Index Graflex.org
Get help with your Graflex questions here
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Biplanat

 
Post new topic   Reply to topic    Graflex.org Forum Index -> Lenses Help
View previous topic :: View next topic  
Author Message
primus96



Joined: 13 Nov 2003
Posts: 225
Location: Yorkshire, United Kingdom

PostPosted: Sat Dec 23, 2006 5:56 pm    Post subject: Reply with quote

This lens: R&J Beck No.3 Biplanat 6 inch focus f5.8 in Unicum shutter.
Can anyone tell me what type of construction it is?
I assume that since it is around 150mm it'll cover 4x5 anyway.
Back to top
View user's profile Send private message
Dan Fromm



Joined: 14 May 2001
Posts: 2119
Location: New Jersey

PostPosted: Sat Dec 23, 2006 9:41 pm    Post subject: Reply with quote

Quote:

On 2006-12-23 09:56, primus96 wrote:
This lens: R&J Beck No.3 Biplanat 6 inch focus f5.8 in Unicum shutter.
Can anyone tell me what type of construction it is?
I assume that since it is around 150mm it'll cover 4x5 anyway.
The Vade Mecum thinks is is a Rapid Rectilinear. If so, it is probably a little short to cover 4x5. Suggest you count reflections and try it out. About counting reflections, each cell of an RR should have two bright and one dim.
Back to top
View user's profile Send private message
primus96



Joined: 13 Nov 2003
Posts: 225
Location: Yorkshire, United Kingdom

PostPosted: Sat Dec 23, 2006 11:23 pm    Post subject: Reply with quote

Does anyone have any call on angle of coverage for a Rapid Rectilinear?
From what I have seen a RR.R. lens is two symmetrical cemented doublets, 4 ele 2 grps.
They came before the likes of the anastigmats like Dagor and Tessars, yes?
A R.R. lens has astigmatism and has anyone used such a lens to see what that means practically speaking?
Back to top
View user's profile Send private message
Dan Fromm



Joined: 14 May 2001
Posts: 2119
Location: New Jersey

PostPosted: Sun Dec 24, 2006 12:48 am    Post subject: Reply with quote

Quote:

On 2006-12-23 15:23, primus96 wrote:
Does anyone have any call on angle of coverage for a Rapid Rectilinear?
From what I have seen a RR.R. lens is two symmetrical cemented doublets, 4 ele 2 grps.
They came before the likes of the anastigmats like Dagor and Tessars, yes?
A R.R. lens has astigmatism and has anyone used such a lens to see what that means practically speaking?
Yes, RRs antedate anastigmats. But reports on them are to the effect that late RRs were every bit as good as anastigmats and were displaced because they cost more to make. And even early ones are supposed to be very good centrally.

So control your impatience and after the lens has arrived ask it what it can do for you.
Back to top
View user's profile Send private message
primus96



Joined: 13 Nov 2003
Posts: 225
Location: Yorkshire, United Kingdom

PostPosted: Sun Dec 24, 2006 11:23 pm    Post subject: Reply with quote

What sorts of other defects might one find in such a early lens design?
I have found that astigmatism may be shown in a image of a bike wheel. If the spokes were sharp then the rim & hub would not be sharp.
If you use a normal lens at around f22 for optimum definition how far down might one need to go with this lens?
It'd give me a starting point for experiments.
Back to top
View user's profile Send private message
Dan Fromm



Joined: 14 May 2001
Posts: 2119
Location: New Jersey

PostPosted: Mon Dec 25, 2006 4:22 pm    Post subject: Reply with quote

Quote:

On 2006-12-24 15:23, primus96 wrote:
What sorts of other defects might one find in such a early lens design?
I have found that astigmatism may be shown in a image of a bike wheel. If the spokes were sharp then the rim & hub would not be sharp.
If you use a normal lens at around f22 for optimum definition how far down might one need to go with this lens?
It'd give me a starting point for experiments.
So far I've had one lens with severe astigmatism, a 1000/11 Celestron C-90. With it, if vertical lines were in focus horizontal lines were out, and vice versa. I don't see how a lens with severe astigmatism could render all of a wheel's spokes sharp and not the rim.

I have no idea what you want to use your new gem for. When I get a new lens, I run it through a fairly simple acceptance test. I have a couple of targets, one near, the other far, that have fine detail at a range of scales. Camera on tripod, shoot each target at each of the apertures I'm likely to use the lens at. Then examine the results closely and compare with previous ones from other lenses.

I think you're making too much of your Biplanat's possible defects. The old lens nuts who use Aplanats have said many times that used within their intended coverage they're very, very sharp. But then, I ignore the old lens bokeh nuts who practice lens abuse.

Good luck, have fun,

Dan
Back to top
View user's profile Send private message
primus96



Joined: 13 Nov 2003
Posts: 225
Location: Yorkshire, United Kingdom

PostPosted: Mon Dec 25, 2006 8:50 pm    Post subject: Reply with quote

The Biplanat will possibly be right at the limit of it's coverage, but i'm prepared to be surprised.
This creature is in a Unicum shutter. I don't know how it works.
The shutter design looks familiar, i'm sure I have seen something lke it on a Rochester made 4x5 plate camera.
Back to top
View user's profile Send private message
primus96



Joined: 13 Nov 2003
Posts: 225
Location: Yorkshire, United Kingdom

PostPosted: Mon Jan 08, 2007 9:32 pm    Post subject: Reply with quote

I was looking for an effect whereby the edges & corners would be very soft indeed, but with a sharp enough centre for portraiture at wider apertures.
Softness would be a positive asset in a portrait.
Back to top
View user's profile Send private message
primus96



Joined: 13 Nov 2003
Posts: 225
Location: Yorkshire, United Kingdom

PostPosted: Sat Apr 11, 2009 9:21 am    Post subject: Update on Beck Biplanat Reply with quote

The Unicum shutter was a POS, no exaggeration. I went to the expense of having SKG re-mount the Beck cells into a Copal #1.
Wide open, at f5.8 I get a very sharp centre & the edges are appropriately much fuzzier. Beck touted the Biplanat as a suitable lens for portraiture and landscapes, and I agree with them after examining my first negatives.
I expose on normal subjects at f16-22, no complaints with the results.
Of course I now have the luxury of flash contact, albeit 'x' sync only.
Not sure about using this lens with bulb flash. I will post on the approprate esction if I want advice on that.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Graflex.org Forum Index -> Lenses Help All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group